Ten Safety Tips of Corn Stover Pellet Mill
Ten Safety Tips of Corn Stover Pellet Mill This article will tell you ten safety tips about the corn stover pellet mill prodused by Amisy.
- Composite Introduction
- Recommend Products
- Related Cases
This article will tell you ten safety tips about the corn stover pellet mill prodused by Amisy.
(A)Straw knitting machinery should be fixed on the ground, you can use cement to fix it and frequently change place of work.
(B)Before starting the straw knitting machinery, rotate the rotor by hand, check the operation flexible and normal; there is collision in the chassis; the rotor rotation direction is correct, good motor and shredder lubrication.
(C)After the installation of the straw knitting machinery, you should carefully check if it is in place, if it is stable enough. Motor shaft and grinder axis is parallel and the belt is tight enough.
(D)Shredders and electric motors should be installed in the base made of angle iron.
(E)Straw knitting machinery feeding should be uniform, if you find noises, bearings, and the body temperature too high or outward spray of material, please immediately stop inspection to shoot.
(F)After 300 hours operation, Straw knitting machinerys should be cleaned bearings, changed oil; oil should be installed to 1/3 of full bearing gap and should not exceed a maximum of1/2. at a long downtime, you should remove the belt.
(G)While feeding, the staff should stand on the side of the straw knitting machinery to avoid being wounded by the debris bounced out. While crushing long stalk hand should not grasp too tight to prevent hands being brought into.
(H)You should stop feeding before straw knitting machinery shutting down, wait until the material inside rule out clean, cut off the power .After the shutdown, please clean it.
(I)Before straw knitting machinery work, staff should carefully check the material to prevent the metal, stones and other hard objects into the crushing chamber to cause the accident.
(J)The pulley of straw knitting machinery should not often be replaced to prevent the speed is too high or too low.
Silicon carbide is a synthetic material with good thermal conductivity and super hardness. It has bee...
This line have a good compact structure, the application of advanced technology, standardized product...
The entire production line is with accurate control process and strict quality control. It is in line...
The features of the production line: environmental protection, high efficiency, save human cost.Equip...
This drying production line was purchased by one leading spirulina processing company in Mexico ,main...
This drying production line was purchased by one leading spirulina processing company in Australia ,m...
This machine was purchased by one chemical material research institute, they purchased one set cabine...